Technological simulation of the resulting bead geometry in the WAAM process using a machine learning model

authored by

B. Denkena, M. Wichmann, V. Boß, T. Malek

Abstract

In contrast to most subtractive processes where a specific tool geometry is available, process planning in the CAD/CAM chain of additive manufacturing is not as accurate unless the deposited geometry is known. Therefore, a dexel-based process simulation for wire and arc additive manufacturing is implemented to predict the resulting geometry of the deposited material depending on the process parameters. In order to make accurate predictions and consider the effects of the process parameters on the geometry, a multi-stage model is developed for three different materials. The results of this prediction pipeline show an R of 0.82 for the width and 0.76 for the height. Finally, the simulation method is evaluated in terms of computational effort, and the ratio of simulation time to process time is found to be reasonable for simulation-based process planning.

Organisation(s)

Institute of Production Engineering and Machine Tools
PhoenixD: Photonics, Optics, and Engineering - Innovation Across Disciplines

Type

Conference article

Journal

Procedia CIRP

Volume

126

Pages

627-632

No. of pages

6

ISSN

2212-8271

Publication date

2024

Publication status

Published

Peer reviewed

Yes

ASJC Scopus subject areas

Control and Systems Engineering, Industrial and Manufacturing Engineering

Electronic version(s)

https://doi.org/10.1016/j.procir.2024.08.269 (Access: Open)