Smart Hydrogel Swelling State Detection Based on a Power-Transfer Transduction Principle
- verfasst von
- Benozir Ahmed, Christopher F. Reiche, Jules J. Magda, Florian Solzbacher, Julia Körner
- Abstract
Stimulus-responsive (smart) hydrogels are a promising sensing material for biomedical contexts due to their reversible swelling change in response to target analytes. The design of application-specific sensors that utilize this behavior requires the development of suitable transduction concepts. The presented study investigates a power-transfer-based readout approach that is sensitive to small volumetric changes of the smart hydrogel. The concept employs two thin film polyimide substrates with embedded conductive strip lines, which are shielded from each other except at the tip region, where the smart hydrogel is sandwiched in between. The hydrogel’s volume change in response to a target analyte alters the distance and orientation of the thin films, affecting the amount of transferred power between the two transducer parts and, consequently, the measured sensor output voltage. With proper calibration, the output signal can be used to determine the swelling change of the hydrogel and, consequently, to quantify the stimulus. In proof-of-principle experiments with glucose- and pH-sensitive smart hydrogels, high sensitivity to small analyte concentration changes was found along with very good reproducibility and stability. The concept was tested with two exemplary hydrogels, but the transduction principle in general is independent of the specific hydrogel material, as long as it exhibits a stimulus-dependent volume change. The application vision of the presented research is to integrate in situ blood analyte monitoring capabilities into standard (micro)catheters. The developed sensor is designed to fit into a catheter without obstructing its normal use and, therefore, offers great potential for providing a universally applicable transducer platform for smart catheter-based sensing.
- Organisationseinheit(en)
-
Fakultät für Elektrotechnik und Informatik
- Externe Organisation(en)
-
University of Utah
- Typ
- Artikel
- Journal
- ACS Applied Polymer Materials
- Band
- 6
- Seiten
- 5544-5554
- Anzahl der Seiten
- 11
- Publikationsdatum
- 10.05.2024
- Publikationsstatus
- Veröffentlicht
- Peer-reviewed
- Ja
- ASJC Scopus Sachgebiete
- Prozesschemie und -technologie, Polymere und Kunststoffe, Organische Chemie
- Elektronische Version(en)
-
https://doi.org/10.1021/acsapm.4c00808 (Zugang:
Offen)